FPGA Selection and Interface all the devices with FPGA.
FPGA – Worked on Artix – 7(XC7A200T-1FBG676I & XC7A200T-1FFG900I), Project design on: RS232/RS422, NOR Flash, RTC, SRAM, USB, EEPROM, Video Encoder, Video Decoder, Nand Flash.
Video Archical Board – This consist of Artix-7, this is used for Video capturing and retrieval of video data. It Consist of PAL Video. It has Nand Flash with 32Gb of memory for storage of video. It has interfaces like SRAM(IS61WV102416BLL), iNAND5130 with storage capacity of 32GB, NOR Flash(N25Q256) for configuring the FPGA and storing Bitstream data, it consist of Video Encoder(ADV7341) & Video Decoder(TVP5146M2).
Video Enhancement Board – This Board has Artix-7, this is used for video enhanced. It is working alone as well as it has also connecting with base card through 120-Pin Samtech Connector and operated through base card.
Hardware testing - Verification of device operation by interfacing with FPGA.
Responsible for studying Specification of Project and then drawing block diagram, IO Calculation for FPGA Selection, Power Calculation, Power Diagram, Power Estimator sheet for FPGA. I am also responsible for netlist checking of design.
Schematic design – I am also responsible for schematic design of every component involve in my project.
Responsible for Footprint Checking of ICs, Connector, Switch and also Responsible for Component Placement.
Sanity Test - Testing Impedance of each supply with respect to Ground and with respe