All the information and the drawing is in the attachment I want to finish in 42 hours I want to the calculation and the safety factor and I want written report
,,,,,,,,,,,,,,,,,,,,,,,,,,,,,,,,,,,,,,,,,,,,,,,,,,,,,,
Screw 3.18mm diameter, 25 mm long weight on 58 grams.
Long screw 3.18mm diameter, 28 mm long, and weight on 62 grams
If you can do the calculations in Microsoft word and write up on them and then expand on our opening it would be a huge help. If you get a large safety factor assume it’s because of expectation of impact
,,,,,,,,,,,,,,,,,,,,,,,,,,,,,,,,,,
Our design project is a model of a multiaxial Quad copter. Our design will hopefully give the copter the ability to move freely in the x,y,z at the same time. Allowing this movement would be new to the field as most quad copters are restricted to 2 directional pivoting. This would allow even more possibilities for quad copters in the future.
To achieve this movement freedom we are going mount two servos ontop of each other. Basically we would have two servos each offering around 180 degrees of in 2 directions. When put together they will be near 360 degrees of motion and will offer the ability to direct the copter to fly upside down or perpendicular to its normal flight.
,,,,,,,,,,,,,,,,,,,,,,,
Our initial design is based off of the current design used for hobby quad copters. The difference is stacking two of them that interact to add the degree of motions together. Our addition is how we are stacking them together.