Arduino set up + 2.8 touch screen + RFID Management

Hi all, We are looking for some support for our product development. I have already bought some components in order to test but according to your recommendations I can buy additional components. here are my current component list: - Arduino Mega 2560 : [login to view URL] - Servo Controller : [login to view URL] - 2.8 TFT Touch Screen (Resistive) : [login to view URL] - Bluetooth (BLE) : [login to view URL] - Servo Motor: [login to view URL] - Batterie : [login to view URL] - NFC/RFID controller breakout board : [login to view URL] - push button : [login to view URL] We are looking for someone who is able to set up a complete system (hardware + software) in order to do following actions: 1. "servo motor" will rotate between only 2 positions (open/close position) 2. If "push button" is engaged then servomotor will rotate from position 1 (open) to position 2 (close), this according to next bullet point 3. The servomotor stays in position 2 until bullet point 5. 3. An IOS application (Ipad) will send, through Bluetooth BLE, a data set up to Arduino in order to define timing between engaged "push button" and "servo motor" rotation, here are available option into IOS application: a. Servo motor will never rotate to position 2 (closed), b. 30 sec after "push button" engaged, Servo motor will rotation to position 2 after, c. Servo motor will rotate to position 2 (closed) immediately after "push button" is engaged 5. the servomotor rotation from position 2 (closed) to position 1 (open), will be commanded thanks RFID card. 6. 2.8 Screen is to give information. It must : a. Give information regarding servo motor current position (1 or 2) b. Give information regarding granted access or not (how many tries) I am expecting to get you a full explanation to mount my proto, the PCB program, as well as very the simple IOS App. I looking forward to hearing from you Thanks & Good luck