I need a curcuit board designed
$30-250 USD
Paid on delivery
I need a curcuit board designed and a list of components needed so that I can build the circuit myself. I have very little electronic component knowledge and no curcuit building knowledge. This information must be presented to me in an understandable way. The curcuit needing to be built is relatively simple. I need a curcuit that can connect to a motor and reverse the polarity of the motor via a timer, such that the motor shaft moves clockwise when the polarity is not reversed, and after a specfic time has elapsed, the motor reverses polarity and the shaft moves counter-clockwise. This design is simillar to that of a curcuit in a garage door opener, however, instead of opening and closing with a button, it opens and closes via a timer.
Project ID: #17966988
About the project
Awarded to:
Hi, Mg name is Junaid and I am an experienced electrical engineer. I will design and simulate circuit for you to control direction of motor. I will use microcontroller so you can adjust time very easily. Deliverable More
4 freelancers are bidding on average $69 for this job
Hi, This can be achieved using DC motor driver LD298 , we can use Arduino to generate a timer you needed. or even actually you can buy ready to use motor driver shield for Arduino and you can start your project withou More
Am full-time freelancer expert in Electrical & Electronic Circuit Designing & Simulation, PCB Designing, Consultancy of different types of Electrical & Electronic Problem. I am ready to give hardworking, reliability, f More