Volvo Amazon hazard light LED friendly

£20-250 GBP

Closed

Posted

over 3 years ago

£20-250 GBP

Paid on delivery

I am building a rally car. To safe battery I have installed LED lights throughout. To overcome indicator problems, the tell tale has been linked to diodes and I have used a LED relay. The hazard lights switch doesn’t work presumable because the LED lights it operates draw too little current. Solution is 6 ohm , 50 W resistors to each blinker light. Not ideal. Problem to be solved. Is it possible to place one single resistor on the non LED relay that attaches to the hazard switch to make the hazard light work? If so to which connectors does it need to be attached and how big does the resistance need to be? Could there be heating problems?

Electrical Engineering

Project ID: 28387903

About the project

5 proposals

Remote project

Active 3 yrs ago

Looking to make some money?

Email address

Benefits of bidding on Freelancer

Set your budget and timeframe

Get paid for your work

Outline your proposal

It's free to sign up and bid on jobs

5 freelancers are bidding on average £145 GBP for this job

@nikitamorozzz

Hello, Dear. I am an experienced electronic engineer and hardware designer. I have designed lots of LED drivers. I can deliver you perfect solution. I hope to help you. Thank you.

£150 GBP in 2 days

5.0

(27 reviews)

5.6

@etalhak

Hello, I am an electronics and telecommunication engineer and I am quite experienced with hardware and embedded systems' design. So far I have designed a couple of LED lighting projects and I also did a couple related tasks(camera placement, LED lighting, etc) to my friends' cars hence I am quite sure that I can help you with your project. Just let me know and I will do my best to help you. Best regards

£140 GBP in 2 days

4.9

(14 reviews)

4.5

@Sanjaysingh2018

I am professional embedded hardware engineer .I have completed my graduation with Electronics engineering. I can help with your problem. As I have experience with design and development of vehicle electronic.

£111 GBP in 2 days

5.0

(1 review)

2.6

@Itblast

If you are looking for Electrical and Electronics engineer you are in the right place. I am a professional Electrical engineer with very good work ethic. I handle projects with 100 % quality assurance and no plagiarism, related to the subjects mentioned below: Engineering circuit analysis Control systems Analog electronics Digital signal processing Power electronics Power transmission Micro controllers Signal and system Electrical measurement and instrumentation Command and experience on the following software's: Cadence IC costume suit MATLAB application in digital signal processing Feel free to contact me regarding the project related to the subjects mentioned above and other task related to electrical and electronics engineering.

£250 GBP in 5 days