I am doing a project to compare results through finite element method (FEM) from software and the measured experimental results of a Magnetic Single Sheet Tester (SST). I need help on creating a model of a single sheet tester on COMSOL. Below is attached a pdf (BS EN 60404) explaining the SST and it's measurements and materials used. I will be using a grain-oriented steel sheet. I need to obtain results most importantly on the values of the B and H but if possible also VA/kg and W/kg similar to the results to be compared experimentally which i also attached (Sheet 1). The results do not have to be similar as they have to be compared and I will calculated the error percentage.
I guarantee excellent results and a high level of detail in the technical documents. I suggest you check my profile about the FEA projects. I am currently simulating a three-phase motor
and I have just finished the design, optimization and simulation of a linear motor of 600N and 40m / s
Hi.. I saw your project and want to help with it if you will accept my proposal. Of course I cannot convince you to but I can give you an assurance of a good job. Thanks.