Arduino Sketch for RPM Tachometer using IR Receiver 1-pin, monitors 3-pin sensor (+ - for IR LED-Emmitter, Monitor-Pin for IR-Receiver)
$10-30 USD
Paid on delivery
I need a simple sketch for an Arduino Nano Mega328P.
* Pin-D9 is the sensor Pin, it connects to the Positive side of the IR-Receiver (Black) LED.
I need to monitor RPM based on an Encoder Disk with two partitions, if the IR-Beam is broken twice, the disk has spun one time within a 60-second term, if the beam breaks one time, it means the disk has moved about 1/2 revolution.
If the beam is broken ten times within a 60-second period it means the disk has spun 5-times... You get the idea.
* It needs to update every second.
Project ID: #7572937
About the project
16 freelancers are bidding on average $30 for this job
hi sir i am an expert electrical engineer I have almost 4 years of experience in design of systems based on arduino I assure you quality work and on time delivery Please consider me for your job i have read the detai More
Hi I'm arduino expert and have done several project with arduino Thank you Chamika Gamage Electronic Engineer
Hello Sir, I am a full time working freelancer and I am available on freelancer most of times and I can provide you the required prototype as you want it. I have very good feedbac More
ACTUAL BIDDER! NOT A SUBCONTRACTOR!!! Hello, i have a PhD in Mechatronics and ample experience with Arduino boards, as well as microcontrollers. I have most of the hardware needed to get this started and have worke More
I can help you .............................................................................................................................................
Hi there, As I understand you need a tachometer updating every second is it ? I will make do the code so that you can see the RPM in the serial monitor. Thank You !
I have experience in micro-controllers programming and arduino boards. i would be glad to help you Best regards
I am an Electrical Engineering student at IIT Bombay, India. I have the code for the Arduino RPM Tachometer ready as per your specifications. I can deliver the sketch within 30 mins with any furthers modifications that More
i was this odometry technique in one of my project . I used wheel encoders to calculate speed so that would give rpm easily and i could do it in a short amount of time.
Hi. Your project is very interesting. I can do it, and I always support even after the project has ended. Thanks.
My forte is software development on microcontrollers using Assembly and ANSI C. I have experience in PIC, NXP ARM-M0, Freescale MCU and Atmel
I can deliver it within 10 hrs if you want. Using 5 ir sensors for my college project. Also written 700 lines of sketch in one night...