My name is Erik.
I am looking for a designer to produce a 3D file of a cardholder of my own design that adheres to the back of a smartphone.
This file will be sent to potential manufactures to showcase the idea in order to move into higher scale production.
The following are the particulars of our product:
Three pockets for standard cards, two pockets open upwards, bottom pocket opens towards the right side allowing a card to slide out horizontally
Gap in the center (front) to slide out bottom card
Back of the cardholder has adhesive to stick on a phone. I have spoken with a potential manufacturer. I intend for the cardholder to be made out of an elastic lycra with a PVC and microfiber component.
Rough Product Specifications taken from very low fidelity prototype made by hand:
*The following measurements are to be used as more of a guideline*
The design will most likely be scaled down and have much tighter tolerances. As I am not an engineer, I do not know how to do this, but I assume this can be done with some trial and error in software.
Pockets must fit standard 85.60 × 53.98 mm ISO/IEC 7810 cards.
Product height: 105 mm
Product width: 67.5 mm
Product depth (thickness): ~2-2.5 mm
Attached is a file with images of our concept.
42 freelancers are bidding on average $169 for this job
We are professions artist team, we have more than 8 years experience, are looking for interesting projects. We are looking for long term relations and reliable clients to work with them. [url removed, login to view]