Adding/subtracting numbers (keypad-LCD)

$30-250 USD

In Progress

Posted

about 12 years ago

$30-250 USD

Paid on delivery

I have a project that is due by Friday April/13/2012. The project is about writing a code and trying to perform the code on a keybad-LCD. The primary goal for the codes is that we're able to add/subtract numbers on the keypad-LCD. The codes must be performed on MPLAB IDE V8.10. In the attachment below, its an example of some codes on how it should be written. It should also include a lab report with full description of the codes and steps. The report must include the following: 1. Purpose • Objective of the project. 2. Procedure/additional equipment/circuits • Include relevant portion of Qwikflash schematic. Cut and paste, or draw, only the relevant portion. If a whole schematic is to be included, the relevant parts should be highlighted. 3. Flowchart • Flowchart should be drawn with Word or Visio (Visio is strongly preferred). No hand drawn or Paint drawn flowchart 4. Program code • Paste the working code from MPLAB 5. Program code Description • Describe how the code works in a paragraph(s). Basically a word description of the flowchart and the program code. 7. Conclusion • Major problems encountered during lab, if any, and how they were solved • Any special measures which had to be taken to ensure proper code function, if any • General comments on how to improve project, if any

Assembly

Codeigniter

Microcontroller

Project ID: 1554921

About the project

5 proposals

Remote project

Active 12 yrs ago

Looking to make some money?

Email address

Benefits of bidding on Freelancer

Set your budget and timeframe

Get paid for your work

Outline your proposal

It's free to sign up and bid on jobs

Awarded to:

@Mathilda33

hi! i can do it.

$200 USD in 8 days

5.0

(9 reviews)

4.4

5 freelancers are bidding on average $165 USD for this job

@reallifetech

Dear Sir, We are Reserach and Development company whose working area are : -Digital Motor Control -Analog Design -Electronic Design -Power Electronics -PCB design -Embedded system -Matlab -Simulation of hardware For each concept descriptions are as follows: Digital Motor Control: -3-phase induction motor vector control drive -Flux estimation algoritm generation -DSP(TMS320) implementation on motor drive -Low speed application -Torque and speed loop generation -Control algoritms Analog design -Low power distribution -Noissless special opamp based analog circuits -Analog filters -Orcad simulation of several circuits Electronic Design -RF transmitter and receiver -Bluetooh reader and transmitter -Magnetic reader Power Electronics -Implementation motor drive -AC/DC converter -DC-DC converter -Battery charger -Solar inverter -Renewable Energy simulations -Uninterruptle power supplies PCB design -Schematic design by Altium -PCB design by Altium -Power board design -SMPS board design Embedded system -PIC18,PIC24,PIC30 and dsPIC applications -Ardino -MSP430 -Atmel -DSP(Texas Instruments) -Renesas Matlab -Power Electronics simulation -Motor drive -Wind Energy -Solar Energy -Control applications Simulation of Hardware -Orcad Simulation(TI,National, Linear Tech, Maxim libraries) -LTI -National -Matlab Very important Note: References attached. Please look excel file to see projects which we made until now! Note: Payments will be funded as: 1)Initial:%25 2)Second stage:%15 3)Third stage:%20 4)Final stage:%40 Metin Akin

$150 USD in 2 days