Expert PIC developer using microchip wifi module

I have long experience with 8-bit and 32-bit micro-controllers. I work with PIC , AVR , ST and NXP micro-controllers. I use KEIL IDE , Atmel Studio and MPLABX IDE . Regarding your project , I can use any PIC micro-controller and I would develop using MPLAB X IDE . I deliver tested , neat and well-commented code that can be reused or modified for future development. More to be discussed once you contact me . BR, M.T.

Hello. I'm an embedded systems engineer with extensive experience with PIC MCUs. I understand you wish to build a system with WiFi connectivity and I can help you achieve this, from schematic to firmware to PCB design. Contact me to discuss details.

I have more than 2 years pf experiance in Electronics. I have worked on Esp8266,Arduino,Raspberry Pi,PIC,Analog Circuit Design,etc. Relevant Skills and Experience Micro controller Programming Embedded Systems PCB Designing Schematic Designing Do message me so we can discuss details.

Sir, I have read your requirements and would like to inform you that me and my team can easily handle this task please share your details to get started

I'm an italian electronic engineer with more than 15 years of work experience. I work as HW designer; FW and SW developer. As HW designer, I work in Altium, KiCad and Orcad and I have experience in development single MCU (Microchip PIC and ARM Cortex) boards with several digital I/O (GPIO, UART, SPI, I2C, PWM,....) and some analog I/O. I design complete board: power section, MCU section, peripheral section,.... I design also boards with battery power; so I have experience in low power PCB design. I have also experience in commercial boards (Arduino, Raspberry, Beaglebone,...) shields design. I have also experience in bluetooth (both 2.0 and 4.0) PCB design. As FW developer, usually I work in C for Microchip PIC (MPLAB X + XC compilers) and Eclipse + GNU ARM for different ARM Cortex M3/M4 manufacturers (STM32Fx, NXP, EFM32 SiLabs, but I'm ready to learn new frameworks). I work both single task and multi task environment (FreeRTOS and RTX). I write code both for low level driver (GPIO, UART, SPI, I2C, PWM....) management and for high level/final application. I work also in "C code" commercial boards Arduino/ESP8266 and Linux embedded commercial boards (Raspberry and Beaglebone). I have also experience in bluetooth (both 2.0 and 4.0) programming. As SW developer, I work in C, C++, .NET, Java, and lot of others programming languages. Mainly I work for Windows O.S., but I have experience in Linux development too. I have experience in openCV library for image/video processing.